WiFi Module DT-06

Model : WIR-00109

Supplier : Made in China

TechshopBD, Bangladesh


1 - 9

10 - 99
BDT410.51Save BDT 7.69

100 +
BDT407.45Save BDT 10.75

Yellow 2 Available Only

You may also be interested in

WiFi Module DT-06

DT-06 Module is based on ESP8285 ESP M2 module and provides easy to use WIFI to any UART Serial port and is pin compatible to HC-06 Bluetooth modules. If a project already uses Bluetooth then you can very easily convert into Wifi without any change in code.

Using the built-in web interface transparent WIFI-UART communcation can be setup for TCP or UDP sockets on any port.

This module requires NO configuration to get started!

This module powers up as a standalone AccessPoint at DOIT_WIFI_XXXX with an IP address of

Any message sent to on port TCP 9000 will be sent to TX/RX @ 9600bps and vice-versa.

Connect module to Arduino or TX/RX of USB to Serial adapter.

Connect phone or PC via Wifi to AccessPoint (SSID will show up as DOIT_WIFI_XXXX or something similar -- no password).

Use a TCP Terminal or your own applications to send and receive messages to and from on port TCP 9000.


Applications Of DT-06 Wifi Module

Smart home, wireless data connection and transparent transmission, smart car control, wireless serial printer, LED light industrial control etc.

  • Fully compatible with the original electrical interface and physical interface for the serial transparent Bluetooth.

  • Built-in the industrial transparent transmission firmware V3.0 with stability and reliability by using the Web Configuration.

  • Built-in the high performance WiFi module ESP-M2 with size : 34mm*17mm*4mm.

  • Working voltage : 4.5V~6.0V, TTL working voltage : 3.3V (compatible with 5.0V).

  • Provided pins : STATE, TXD, RXD,EN.

  • Average current : 80mA; when data sent, it is 170mA; but it is 20μA at deep sleep mode.

  • Support serial AT command.

  • Support re-programmable, OTA firmware update.

  • Seamless transparent transmission between serial and WiFi.

  • Built-in HTTP Web Server, support configure parameters by web page.

  • Support re-connect automatically at WiFi STA mode and TCP Client.

  • Support set baud rate, data bit, parity check, stop bits, and/or subcontracting time.

  • Support baud rate (bps) 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 74800, 115200, 230400, 460800, 921600, 1843200, 3686400.

  • Support AP enable, self-defined SSID/password, self-defined IP and network duration.

  • Automatically scan the peripheral WiFi hotspot, support STA enable,DHCP, self-defined IP.

  • Support TCP Server, TCP Client, UDP Server, UDP Client and UDP local broadcast.

  • Support DNS resolution automatically for the remote sever address.

  • Support checking the status by AT commanD.

  • Provide IO4 to show the WiFi status.

  • Working temperature : -40°C-125°C.

Login to post comments.

Copyright © 2012-13 Techshop Bangladesh. All rights reserved.