Model : MIC-00032
The high-performance, low-power Atmel 8-bit AVR RISC-based microcontroller combines 32KB of programmable flash memory, 2KB SRAM, 1KB EEPROM, an 8-channel 10-bit A/D converter, and a JTAG interface for on-chip debugging. The device supports throughput of 16 MIPS at 16 MHz and operates between 4.5-5.5 volts.
By executing instructions in a single clock cycle, the device achieves throughputs approaching 1 MIPS per MHz, balancing power consumption and processing speed.
- CPU:8 Bit AVR
- Flash:32 KBytes
- SRAM:2 KB
- Maximum I/O Pins:32
- Maximum Operating Frequency:16 MHz
- ADC:10 Bit
- Timers:3 Nos
- Operating Voltage:
- – 2.7V - 5.5V for ATmega32L
– 4.5V - 5.5V for ATmega32
Login to post comments.
Tareq | May 16,2014 at 06:33 PM
i need atmega32u. or atmega8u. you use it to make avr programmers, but don't sell.... why?
A.R | May 18,2014 at 09:26 AM
Sorry, our programmers are based on Atmega8A not 32U or 8U.
Tareq | May 18,2014 at 09:39 PM
... are you sure ? but your AVR programmer dont have any FTDI chip ! how come it can communicate over USB ?? Is it possible to interface AtMega8A directly with USB ?
A.R | May 19,2014 at 12:21 PM
This programmer is as same as USBASP. The USB communication is handled by the firmware.
Tanvirjewel | May 29,2017 at 10:50 PM
If i made a circuit ands use this ,do i need to add any Crystal oscillator for that.
A.R | May 30,2017 at 09:58 AM
Please study the datasheet. Internal crystal is upto 8MHz. For more speed, you'll need oscillator.
Ryan_Imam | May 20,2018 at 05:49 PM
i need 1 atmega 32A..how to order??
A.R | May 21,2018 at 10:42 AM
Please order according to this shopping guideline. https://www.techshopbd.com/newTheme/images/banglashoppingguideline.pdf